Optima's T:LAN NetPro e Series universal access units provide cost-effective, scalable, and highly reliable solutions for remote LAN access, RS-232 console port communications and alarms collection.
Optima's T:LAN is ideally suited to extend network management and supervisory control of multi-vendor equipment in central office, co-location, substation, CEV's, cellular, microwave radio, and point-of-presence sites.
Each unit comes ready-to-go out of the box. Unpack, rack-mount and hook-up! Remote connectivity has never been easier.
Physical Dimensions
Size (HxWxD)
4.45cm x 44.45cm x 15.24cm (1.75" x 17.5" x 6.0") Weight
2.3 kg (5.0 lbs) Mounting
1 RU, fits standard 19"/23" racks, rack-mount (flush/offset/center), table top/shelf mounting, wall mounting
Power
DC Input
Redundant, wide ranging, 18VDC to 60VDC, positive or negative Power Consumption
Less than 7 Watts Connector
Dual 3 position (+/-/FGND), Tyco MATE'N'LOK™, latched Indicators
Power LED AC Input (External AC/DC Adapter Option)
Universal input, 90-264VAC, 40 Watts output
Environmental
Temperature
0 to 50ºC (32 to 122ºF) Humidity
Up to 80% relative humidity (non-condensing)
DS1 WAN Interfaces
Line Rate
1.544 Mbps, +/- 32ppm Fractional
n x 64kbps, n x 56kbps Line Code
AMI, B8ZS Framing
FT, D3/D4, ESF, SLC96 Impedance
100 ohms (Balanced) Input Sensitivity
0 to -36.0dB Output Modes
Short Haul (DSX-1 655ft), Long Haul (DS1 6000ft) Line Build-Out
0 to -22.5dB in 7.5dB steps Clocking
Internal, Loop Recovered Loopbacks
CSU Loopback codes, Line Loopback, Payload Loopback Fail-Over
Signal Bypass WAN 1 To WAN 2 (only available on Dual T1/E1 WAN models) Connectors
2x RJ45 Indicators
Sync, Loopback, Loss of Signal (LOS), Remote Alarm Indication (RAI)
LAN Interfaces
Type
Switched Auto-Sensing, 10-BaseT, 100-BaseTX, Auto MDI/MDI-X VLAN Switching
IEEE802.1Q, port based VLANs Transport
IEEE802.3 traffic, VLAN trunks, ISL, IP/non-IP based protocols Connectors
4x RJ45 Indicators (Per Port)
Rx/Tx Activity/Link, Full Duplex/Collision, Speed (10/100)
Serial Interfaces
Front Panel Port
Local/Craft RS-232 Interface Connector
DB9(S) Configuration
600 to 19.2kBaud, 5 to 8 data bits, 1/2 stop bits, no/odd/even parity, no flow control Back Panel Ports
RS-232 Serial Interface Connectors
4x RJ45 Configuration
150 to 115200 Baud, 5 to 8 data bits, 1/2 stop bits, no/odd/even parity, no flow control Expansion (Option)
Externally expandable up to 20 ports via SPX modules
Alarm I/O
Contact Inputs
32 Contact Inputs, ground referenced, triggered by switching to ground or applying a negative voltage (up to -60VDC) Relay Outputs
3, Form A, 60V 500mA maximum Analog Inputs
4 Analog Inputs, 2 at ±64VDC (125mV resolution), 2 at ±6.4VDC (12.5mV resolution) Power Outputs (For External Devices)
2 12VDC Power Outputs (100mA each) OneWire Interface
1 OneWire Interface for External Remote Temperature Sensors Connector
2 DB-25 (female) Power Monitoring
Integrated A and B DC Power Supply Input Monitoring (8mV resolution)
External Alarm Expansion (RIO Modules)
Connector
RJ45
Modem (Option)
Type
V.92 Speed
Up to 56,000bps Connector
RJ45
Protocols
ARP/RARP [RFC826/903], DHCP [RFC1534/2131-2132], ICMP [RFC792], IP [RFC791/894/950/919/1122], NTP/SNTP [RFC1305/2030], PPP [RFC 1321/1332/1334/1471/1638/1661-1662/1841/1994/2878], SNMP [RFC1067/1089/1155-1157/1212-1213/1215/1493/1643/1905-1907/2495], TCP [RFC793/813/879/2018], TELNET [RFC854/856/857/858], UDP [RFC768]
User Interface
TELNET, VT-100, menu driven, embedded on-line help
Safety and Regulatory Approvals
UL 60950 3rd Edition, CAN/CSA-C22.2 No. 60950-00, IEC 60950, FCC 47 CFR Part 15, FCC 47 CFR Part 68, ICAN CS-03, EN 300-386-21997, EN 550221998, CE
